The RT Logic Telemetrix® Link Simulation and Test Equipment products provide flexible, cost-effective solutions for communications link test applications. High fidelity performance testing, training, simulations and BER loopback testing are facilitated by the software-defined RT Logic products shown below. Applications in SATCOM, satellite, and missile link testing benefit from using these systems either in stand-alone mode or as part of a larger, fully integrated test suite. Note, for more details on our capability for supplying fully integrated turnkey systems check out our Satellite Test STE page.
T400CS Channel Simulator:
  • Time Delay, Doppler, Range, Fading
  • Smooth, Phase Continuous Operation
  • LEO, MEO, GEO Simulation
  • Flexible RF or IF interfaces
  • Control via Analytical Graphics STK SW
  • More Info | PDF | Contact Us
T400MT Missile Tester:
  • Emulated RF, IF, Analog and Digital Interfaces
  • Uplink Emulation & Downlink Demodulation
  • Realistic Testing of RF Data Links, Radar Seeker, Radar Fuse, Guidance, and GPS Subassemblies
  • More Info | PDF | Contact Us
T400RTS Range Test System:
  • Full-loop, Long Distance Range Testing at RF
  • No Flying Assets Required
  • Complete Mission Planning and Visualization with AGI
  • Numerous RF Power, Frequency and Antenna Options
  • More Info | PDF | Contact Us
T400UTM UAV, Target, and Missile Test System:
  • Full RF or IF Test Without Flying Assets
  • Phase-continuous dynamic Doppler, delay and attenuation
  • Unintentional and jammer interference capability
  • Wide range of RF options
  • More Info | PDF | Contact Us
T400TSS Waveform Signal Generator:
  • Single or Multi-Channel Operation
  • Satellite and Missile Test Applications
  • Flexible Support for a wide range of modulation types
  • Local/Remote Control with GUI support
  • More Info | PDF | Contact Us
Supporting Product Data - note that boards are normally sold only as part of a fully integrated system:

DG4000 High Rate Converter- The cPCI (Compact-PCI) based DG4000 is an FPGA-based, software-defined radio platform. The DG4000 supports IF and baseband processing applications, as well as high rate Digital-to-Analog conversion. The DG4000s high-rate digitizer and converter are tightly coupled to a Xilinx Virtex-4 FPGA for customizable firmware-based signal processing. An optional Fiber interface streams output data bat up to 2.125 Gbps. Multiple FPGA personalities can be downloaded to the DG4000 for full the range of supported personalities, call us.
PDF | Contact Us